TECHNICAL LIBRARY · ASTM PROCUREMENT REFERENCE

ASTM F269-60(2025) — Tungsten Wire Sag Testing

Procurement reference for determining sag behaviour of tungsten wire within the method’s defined diameter scope.

Edition control: Active; ASTM F269-60 reapproved in 2025. This original MNK-G.S.A summary does not reproduce or replace the protected ASTM publication. Confirm the current authorised edition and governing order documents before use. Values in the inch-pound system govern; SI conversions are informational only.

Scope in Procurement

ASTM F269-60(2025) describes sag testing of tungsten wire with a diameter ≥0.03 in (≥0.76 mm).

The test uses a prepared wire specimen, controlled forming, fixture geometry and heating conditions to produce a comparable sag result.

The method does not apply automatically to every fine wire, finished filament, TIG electrode or unsupported product geometry. Diameter, surface condition and customer acceptance basis must be checked first.

PropertySag behaviour
Product contextTungsten wire within the defined diameter scope
Procurement roleMethod and comparative-result control
Scope boundaryDoes not govern all fine wire, filaments or electrode products

Source and technical review for this scope summary

Where This Standard Fits

  • Nonsag tungsten-wire inquiries
  • Electronic and high-temperature wire qualification
  • Method alignment between manufacturer and customer
  • Supporting wire acceptance where sag behaviour is specified

Ordering and Document Controls

  • Exact ASTM edition and wire type
  • Nominal diameter and method applicability
  • Surface condition and specimen length
  • Forming, fixture and heating conditions
  • Measured result and agreed acceptance basis
  • Batch identification, report identification and traceability

Official Publication and Access Policy

Official record: ASTM F269-60(2025) at ASTM International. Obtain authorised content through the publisher or an authorised standards distributor. Protected clauses, tables, figures and acceptance values are not reproduced here.

Send Your Standards-Based Inquiry

Send the required material, grade, product form, drawing, dimensions, quantity, governing standard, inspection route and delivery destination. MNK-G.S.A will review the specification and coordinate a sourcing response.

MNK-G.S.A | Industrial Procurement & Sourcing | mnkmetals.com | sales@mnkmetals.com

Technical Sources & Revision

Source: ASTM International. ASTM F269-60(2025)

Document / edition: ASTM F269-60(2025)

Source used for: The public ASTM International catalogue record supports the document identity, edition and scope summary on this page. It is used for the stated material or product coverage and the named test or inspection method, where applicable. It does not establish product conformity or replace numerical requirements in the full publication.

Technical source review:

Review scope: the public publisher record and this procurement summary, not a clause-by-clause audit of the full standard. For acceptance, use the governing publication, purchase specification and product or test documentation.

Back to top